DHT11 Humidity + Temperature Sensor Dengan LCD 16×2

Menampilkan nilai dari DHT 11 ke LCD 16×2 berikut contoh programnya :

//We'll start by adding our libraries
#include <LiquidCrystal.h>
#include <SimpleDHT.h>

//Declaring digital pin no 6 as the dht11 data pin
int pinDHT11 = 6;
SimpleDHT11 dht11;

//Declaring the lcd pins
const int rs = 12, en = 11, d4 = 5, d5 = 4, d6 = 3, d7 = 2;
LiquidCrystal lcd(rs, en, d4, d5, d6, d7);

void setup() {
  lcd.begin(16, 2);

void loop() {

  //These serial codes are for getting readings on the port screen aswell as the LCD display, since they'll offer us a more detailed interface
  Serial.println("DHT11 readings...");

  byte temperature = 0;
  byte humidity = 0;
  int err = SimpleDHTErrSuccess;

  //This bit will tell our Arduino what to do if there is some sort of an error at getting readings from our sensor
  if ((err = dht11.read(pinDHT11, &temperature, &humidity, NULL)) != SimpleDHTErrSuccess) {
    Serial.print("No reading , err="); Serial.println(err);delay(1000);
  Serial.print("Readings: ");
  Serial.print((int)temperature); Serial.print(" Celcius, ");
  Serial.print((int)humidity); Serial.println(" %");
  //Telling our lcd to refresh itself every 0.75 seconds
  //Choosing the first line and row
  //Typing Temp: to the first line starting from the first row
  lcd.print("Temp: ");
  //Typing the temperature readings after "Temp: " 
  //Choosing the second line and first row
  //Typing Humidity(%): to the second line starting from the first row
  lcd.print("Humidity(%): ");
  //Typing the humidity readings after "Humidity(%): "


We will be happy to hear your thoughts

Leave a reply